Plant concept · Fission

High-temperature gas reactor.

The high-temperature gas reactor reference plant concept in 3D. Open a site from the globe, or from the list beside the view, to see its real numbers next to it.

Show this family on the globe
Close view of the illustrative high-temperature gas-cooled reactor concept: a tall reactor vessel cut open to show a bed of fuel spheres inside its graphite reflector and control-rod drives under the head, joined by a short coaxial duct to a shorter steam generator column with tube coils inside and a finned helium circulator on top, inside an open steel building frame.REFERENCE CONCEPT · NOT A SIMULATION

Reference still · interactive view loads when available

Reference concept · Concept study · HTGR

The high-temperature gas-cooled reactor reference plant.

The family’s reference concept, not any one station. The model illustrates a high-temperature gas reactor concept, with the generic layout every design in the plant library shares: the reactor island, a turbine hall, air-cooled condensers and a grid connection. It does not show a real station's buildings, number of units, cooling or equipment.

Shidao Bay runs two of these reactor modules into one shared turbine; the concept draws one module. Fort St. Vrain, Peach Bottom-1 and Japan’s HTTR are prismatic designs that hold their fuel in graphite blocks or rods instead of a bed of loose spheres, and Fort St. Vrain and THTR-300 housed the core and steam generators in one prestressed-concrete vessel rather than two steel vessels side by side.

Explore the documented two-module reference, vessel and fuel pebble →

Helium flows down through a tall bed of graphite fuel spheres, each holding thousands of ceramic-coated fuel particles, and leaves the core at about 750 °C. A coaxial duct carries the hot helium to a separate steam generator, where helical tube bundles raise steam, and the circulator on top of that vessel sends the cooled helium back to the reactor.

Fuel
Coated-particle fuel in graphite spheres
Reaction
Splitting heavy nuclei
Energy transfer
Helium primary circuit to a steam generator

The arrangement follows the published HTR-PM pebble-bed module: reactor and steam generator vessels side by side and vertically offset, a coaxial hot-gas duct, the helium circulator on the steam generator and continuous fuel recirculation with a burnup check. The module is drawn at about 0.6 scale to fit the shared building, and a few thousand display spheres stand in for about 420,000 in each core; internals spacing, nozzle counts, supports and routing are illustrative.

Concept source: IAEA ARIS · Advances in SMR Technology Developments (2018), HTR-PM. Procedural geometry drawn for teaching: source anchors are identified in the component records; other dimensions and placement are illustrative. No physics results are computed.

Spotter’s guide · HTGR

High-temperature gas reactor

Helium removes heat from coated-particle fuel in graphite. Designs may use pebble beds or prismatic blocks. The linked two-module pebble-bed reference is one arrangement, not a model for every HTGR, AGR or gas-cooled reactor.

HTR-PM · Xe-100